Cisco Cisco Unified Customer Voice Portal 10.5(1)
Step 1
In the Telnet window for the gateway, use the show run command to examine the configuration
that the gateway is now running.
that the gateway is now running.
Step 2
Compare the new running configuration with the changes in GWConfigChgs_gsExs.txt.
Especially check the application and dial-peer sections of the configuration and verify that the
CVPSelfService, HelloWorld, and customhelloworld application, dial-peer configurations, and
IP references are as expected.
Especially check the application and dial-peer sections of the configuration and verify that the
CVPSelfService, HelloWorld, and customhelloworld application, dial-peer configurations, and
IP references are as expected.
Save the New Running Configuration to the Startup Configuration File
In this task, you will save the new, combined running configuration as a new startup
configuration.
configuration.
Note: This procedure assumes that you have already saved your original startup configuration.
If you have not saved the original startup-config file (or saved your original running
configuration), you are urged to do that first. Refer to
If you have not saved the original startup-config file (or saved your original running
configuration), you are urged to do that first. Refer to
.
Step 1
Copy the running configuration to the startup configuration file to save in NVRAM in case the
Gateway reboots. At the command prompt, type:
Gateway reboots. At the command prompt, type:
copy running-config startup-config <Enter>
Or just:
copy running startup <Enter>
Type <Enter> at the verification prompt.
Load the New Voice Gateway Application Services
Application services were automatically loaded when the gateway started, or when you "reload"
the gateway software. However, when you modified the running configuration, you added
several services which are not yet running. Instead of reloading the gateway, use the following
procedure to start each of the new services.
the gateway software. However, when you modified the running configuration, you added
several services which are not yet running. Instead of reloading the gateway, use the following
procedure to start each of the new services.
Note: Even though you have not yet created the customhelloworld application, you have defined
its service in the new gateway configuration and you can load that service on the gateway, along
with the others in the new running configuration. In the customhelloworld exercise, you will
create that application and load it onto the VXML server.
its service in the new gateway configuration and you can load that service on the gateway, along
with the others in the new running configuration. In the customhelloworld exercise, you will
create that application and load it onto the VXML server.
Step 1
If necessary, log into the voice gateway and enter enable mode by typing:
en <Enter>
on the
command line and supplying the enable mode password.
Step 2
For each of the following application services, type the command:
call application voice load <service-name> <Enter>
Getting Started with Cisco Unified Customer Voice Portal Release 8.0(0)
59
Chapter 5: Unified CVP VXML Server Standalone Call Flow Model Exercise (HelloWorld)
Configure Your Voice Gateway for VXML Server Calls