Cisco Cisco TelePresence MX700 Maintenance Manual
D15331.04 MX700 and MX800 Administrator Guide CE8.2, OCTOBER 2016.
www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved.
86
Cisco TelePresence MX700 and MX800
Administrator Guide
1. Remove the left side cover of the video system to get
access to the codec connector panel.
The cover snaps to magnets.
The cover snaps to magnets.
Reset button
(pin hole)
2. Use the tip of a pen (or similar) to press and hold the
recessed reset button until the screen turns black
(approximately 10 seconds). Then release the button.
Factory reset using the reset button
We recommend that you back up the log files and configuration of
the video system before you continue with the factory reset.
Factory reset the video system
(page 2 of 2)
3. Wait while the video system reverts to the default factory
settings. The video system restarts automatically when
finished. This may take a few minutes.
The video system confirms the factory reset by displaying
The video system confirms the factory reset by displaying
a notification on the main screen. The notification
disappears after approximately 10 seconds.
Introduction
Configuration
Peripherals
Maintenance
System settings
Appendices
Maintenance