Cisco Cisco TelePresence MX700 Maintenance Manual
D15331.02 MX700 and MX800 Administrator Guide CE8.1, APRIL 2016.
www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved.
44
Cisco TelePresence MX700 and MX800
Administrator Guide
Set up Intelligent Proximity for content sharing
(page 4 of 4)
About privacy
In the Cisco Privacy statement and the Cisco Proximity
Supplement you find information about data collection in the
clients and privacy concerns that needs to be considered
when deploying this feature in the organization. Refer to:
You can temporarily disable Proximity in a meeting from the Touch
controller. This is useful in meetings where you want to prevent
devices in the room from receiving content.
You cannot temporarily disable Proximity if using the TRC6 remote
control.
Room considerations
Room acoustics
• Rooms with hard surfaces may cause challenges due to
severe audio reflections. Acoustical treatment of meeting
rooms is always highly recommended for the best meeting
experience as well as Intelligent Proximity performance.
• Cisco recommends only one video system with Intelligent
Proximity enabled in a room. Otherwise, interference is likely
to occur, which may lead to problems with device discovery
and session maintenance.
Basic troubleshooting
Cannot detect devices with Proximity clients
• Some Windows laptops are not able to record sound in the
ultrasound frequency range (20
kHz-22
kHz). This can be due
to frequency limitations with the sound card, sound driver or
the internal microphone of the particular device. Refer to the
Support forum for more information.
Audio artifacts
If you can hear audio artifacts, like humming or clipping noise,
decrease the maximum ultrasound volume (Peripherals > Pairing
> Ultrasound > Volume > MaxLevel).
Additional resources
Cisco Intelligent Proximity site:
Support forum:
Introduction
Configuration
Peripherals
Maintenance
System settings
Appendices
Configuration