Cisco Cisco Application Extension Platform for SRE
Cisco Application eXtension Platform 1.1 User Guide
Configuring the Application Service Environment
79
Cisco Application eXtension Platform 1.1 User Guide
OL-14815-01
DETAILED STEPS
Logging
This section consists of:
•
•
•
Command or Action
Purpose
Step 1
configure terminal
Example:
router# configure terminal
Enters global configuration mode.
Step 2
interface
type number
Example: interface GigabitEthernet0/0
Selects an interface to configure and enters interface
configuration mode.
configuration mode.
type— Type of interface to be configured. For example
GigabitEthernet.
GigabitEthernet.
number— Module and port number.
Step 3
description
string
Example:description
$ETH-LAN$$ETH-SW-LAUNCH$$INTF-INFO-GE 0/0
Adds a description to an interface configuration.
string—Clue to help you remember what is attached to this
interface. This string is limited to 238 characters.
interface. This string is limited to 238 characters.
Step 4
ip address
ip-address network-mask
Configures the IP address and network mask for the
specified network interface.
specified network interface.
Step 5
duplex auto
(Optional) Configures the duplex operation on an interface.
auto—Specifies the autonegotiation capability. The
interface automatically operates at half or full duplex,
depending on:
interface automatically operates at half or full duplex,
depending on:
•
Environmental factors, such as the type of media.
•
Transmission speeds for the peer routers, hubs, and
switches used in the network configuration.
switches used in the network configuration.
Step 6
speed auto
(Optional) Configures the speed for a Fast Ethernet
interface.
interface.
auto—Turns on the Fast Ethernet autonegotiation
capability.
capability.
The interface automatically operates at 10 or 100 Mbps
depending on:
depending on:
•
Environmental factors, such as the type of media.
•
Transmission speeds for the peer routers, hubs, and
switches used in the network configuration.
switches used in the network configuration.
Step 7
analysis-module monitoring
Enables packet monitoring on an interface.
Step 8
no keepalive
Disables the ability to send keepalive packets.
Step 9
end
Exits interface mode.