Cisco Cisco CRS-X Multishelf System Installation Guide
c) Using two people (one person working on each dolly unit), lower the chassis (see this figure) to within 1 in. of the
floor. See the height label on the dolly lift wheel assembly.
Figure 20: Lowering the Chassis
d) Depending on the transport route and the moving space requirements at your site, the dolly can be used to move the
chassis in the 90-degree or 180-degree configuration. The 180-degree position is the recommended configuration for
moving the chassis.
moving the chassis.
To reduce the risk of dolly instability, chassis damage, or personal injury, do not raise the equipment more
than 1 in. (2.54 cm) above the floor during transportation. Statement 358
than 1 in. (2.54 cm) above the floor during transportation. Statement 358
Warning
What to Do Next
After performing this task, move the chassis.
Moving the Cisco CRS 16-Slot Line Card Chassis
This section describes the things to consider as you move the chassis from the loading dock to the installation site. This section
contains the following topics:
contains the following topics:
30