Cisco Cisco CRS-X Multishelf System Installation Guide
Steps
To move the unpacked chassis, follow these steps:
Procedure
Step 1
With a person on each side of the chassis, turn all four lifting cranks of the dolly slowly clockwise. Lift the dolly to the
“Transport” marking on the height label on each lift assembly leg. The dolly can be used to transport the chassis. To reduce
the risk of dolly instability, chassis damage, or personal injury, do not raise the equipment more than 1 in. (2.54 cm) above
the floor during transportation which is the standard recommendation for flat surfaces and thresholds.
“Transport” marking on the height label on each lift assembly leg. The dolly can be used to transport the chassis. To reduce
the risk of dolly instability, chassis damage, or personal injury, do not raise the equipment more than 1 in. (2.54 cm) above
the floor during transportation which is the standard recommendation for flat surfaces and thresholds.
The dolly has four separate lifting cranks, each of which works independently. It is best to turn each lifting crank
simultaneously when lifting the chassis to keep the chassis as level as possible so as to not put undue stress on
the chassis frame or dolly and to reduce the risk of tipping.
simultaneously when lifting the chassis to keep the chassis as level as possible so as to not put undue stress on
the chassis frame or dolly and to reduce the risk of tipping.
Note
The Cisco CRS 16-slot LCC is heavy and tall, and it must be handled carefully to eliminate the risk of tipping
the chassis over. We recommend that at least two people handle and move the chassis.
the chassis over. We recommend that at least two people handle and move the chassis.
Caution
Remove physical layer interface modules (PLIMs), modular service cards (MSCs), and power shelves before you
move the chassis, if they are installed. There is less chance of tipping when no cards, modules, or shelves are
installed.
move the chassis, if they are installed. There is less chance of tipping when no cards, modules, or shelves are
installed.
Note
The 180-degree position is the recommended configuration for moving the chassis. If needed because of site
requirements, rotate the dolly to the 90-degree position. If you are transporting in a 90-degree configuration, then
have at least two people moving the chassis to prevent any transporting hazard. See the
requirements, rotate the dolly to the 90-degree position. If you are transporting in a 90-degree configuration, then
have at least two people moving the chassis to prevent any transporting hazard. See the
Configuration, on page 39
section for further information.
Note
You must lower the chassis completely to the floor before rotating the outrigger legs to minimize the risk of
tipping. When you have rotated the dolly, raise the chassis again. See the
tipping. When you have rotated the dolly, raise the chassis again. See the
on page 39
section for further information.
Note
Step 2
Unlock the dolly caster antirotation and brake systems.
The dolly is optimized to move the chassis on flat surfaces. It is not designed to move the chassis up stairs, over
curbs, up ramps, or over bumps more than 1.5 inches high (such as door thresholds).
curbs, up ramps, or over bumps more than 1.5 inches high (such as door thresholds).
Note
36