Cisco Cisco CRS-X Multishelf System Installation Guide
Step 3
Carefully remove the PDU kit from the rack.
Installing a Single PDU in a Cisco CRS-8 PDU Kit
This section describes how to install a single AC Delta or AC Wye PDU in the 19-inch rack tray.
This section describes how to install a single AC Delta or AC Wye PDU in the 19-inch rack tray.
Although there are differences between the AC Delta and AC Wye PDU, they are installed in the same
manner.
manner.
Note
Prerequisites
Before you begin this procedure, ensure that power is disconnected from the Cisco CRS PDU being
installed. Remove the PDU input plug from the branch circuit outlet.
installed. Remove the PDU input plug from the branch circuit outlet.
Caution
Required Tools and Equipment
The following tool is required to install a single PDU in the 19-inch rack tray:
The following tool is required to install a single PDU in the 19-inch rack tray:
• Number 1 x 6 in. Phillips screwdriver
You can use an offset number 1 Phillips screwdriver to tighten the AC cord clamp that was available
pre-June 2011, but this is optional. The offset screwdriver is in addition to, not instead of, the straight
screwdriver. An offset screwdriver is not required to tighten the AC cord clamp that is available from
June 2011 onwards.
pre-June 2011, but this is optional. The offset screwdriver is in addition to, not instead of, the straight
screwdriver. An offset screwdriver is not required to tighten the AC cord clamp that is available from
June 2011 onwards.
Note
Steps
To install the single PDU from the 19-inch rack tray, perform the following steps:
To install the single PDU from the 19-inch rack tray, perform the following steps:
23