Cisco Cisco CRS-X Multishelf System Installation Guide
Cord removed from clamp
3
Screw that secures the cord
clamp
clamp
1
Screwdriver to loosen screw
2
In the above figure, the cord clamp shown on the left was available until June 2011, and the cord clamp shown
on the right is available from June 2011onwards. The location of the screw that secures the cord in the cord clamp
is different.
on the right is available from June 2011onwards. The location of the screw that secures the cord in the cord clamp
is different.
Note
Step 2
Use the appropriate tool to remove the four screws—two on each side—attaching the rack mounting brackets on the PDU
to the rack vertical mounting brackets.
to the rack vertical mounting brackets.
Figure 19: Removing PDU from Rack
Step 3
Carefully remove the PDU from the rack and place on the workstation.
Installing PDU Kit to Side of Cisco CRS 16-Slot Line Card Chassis
This section describes how to install an AC Delta or AC Wye PDU on the side of the Cisco CRS 16-slot line card chassis. This section
contains the following procedures:
contains the following procedures:
32