Cisco Cisco DX70 Technical References

D15363.02

 Cisco TelePresence DX70 and DX80 API Reference Guide CE8.2, SEPTEMBER 2016. 

Copyright © 2016 Cisco Systems, Inc. All rights reserved. 

45

Cisco TelePresence DX70 and DX80

API Reference Guide

Audio configuration

xConfiguration Audio DefaultVolume

Define the default volume for the speakers. The volume is set to this value when you switch on 

or restart the video system. Use the Touch controller or remote control to change the volume 

while the video system is running. You may also use API commands (xCommand Audio Volume) 

to change the volume while the video system is running, and to reset to default value.

Requires user role: ADMIN, USER
Default value: 50

USAGE:

xConfiguration Audio DefaultVolume: 

where

: Integer (0..100)

Select a value between 1 and 100. This corresponds to the dB range from -34.5 dB to 

15 dB, in steps of 0.5 dB). If set to 0 the audio is switched off.

xConfiguration Audio SoundsAndAlerts RingTone

Define which ringtone to use for incoming calls.

Requires user role: ADMIN, USER
Default value: Sunrise

USAGE:

xConfiguration Audio SoundsAndAlerts RingTone: 

where

: Sunrise/Mischief/Ripples/Reflections/Vibes/Delight/Evolve/Playful/Ascent/

Calculation/Mellow/Ringer

Select a ringtone from the list.

xConfiguration Audio SoundsAndAlerts RingVolume

Define the ring volume for incoming calls.

Requires user role: ADMIN, USER
Default value: 50

USAGE:

xConfiguration Audio SoundsAndAlerts RingVolume: 

where

: Integer (0..100)

The value goes in steps of 5 from 0 to 100 (from -34.5 dB to 15 dB). Volume 0 = Off.

xConfiguration Audio Input MicrophoneMode

This setting only applies to DX80.
The DX80 has microphones in both legs. If you set the microphone mode to Focused, the 

microphones can be combined to focus sound sensitivity. As a result, the noise in the room is 

suppressed, and you can be heard better when sitting right in front of the video system. The 

voice of people not sitting right in front of the system will be suppressed.
If you set the microphone mode to Wide, the system behaves like any other system. The voice 

of people sitting beside you will be heard, and also more noise from the room.
We recommend that you use Focused mode when you are the only speaker. Use Wide mode 

when several speakers are in front of the system. 

Requires user role: ADMIN
Default value: Wide

USAGE:

xConfiguration Audio Input MicrophoneMode: 

where

: Focused/Wide

Focused: Focused sound sensitivity, suppressing sound from sources that are not right 

in front of the video system.

Wide: Default microphone operation with normal sound sensitivity.

Introduction

About the API

xConfiguration

Appendices

xCommand

xStatus



xConfiguration