Cisco Cisco DX70 Technical References
D15363.02
Cisco TelePresence DX70 and DX80 API Reference Guide CE8.2, SEPTEMBER 2016.
Copyright © 2016 Cisco Systems, Inc. All rights reserved.
98
Cisco TelePresence DX70 and DX80
API Reference Guide
xCommand CallHistory Recents
Retrieve aggregated information on previous calls made on the video system.
Requires user role: ADMIN, USER
USAGE:
xCommand CallHistory Recents [Filter:
Filter
] [Offset:
Offset
] [Limit:
Limit
]
[DetailLevel:
DetailLevel
] [SearchString: "
SearchString
"] [CallHistoryId:
CallHistoryId
] [Order:
Order
]
where
Filter: All/Missed/AnsweredElsewhere/Forwarded/Placed/NoAnswer/Received/Rejected/
UnacknowledgedMissed
You can filter which calls to retrieve.
Offset: Integer (0..65534)
Sets the call from which to start.
Limit: Integer (0..65534)
Defines the amount of calls in the output.
DetailLevel: Basic/Full
Sets the level of detail for the information on these calls.
SearchString: String (0, 255)
Allows you to set the command to apply to a specified display name or call back
number.
CallHistoryId: Integer (0..65534)
CallHistoryId for the call in question.
Order: OccurrenceTime/OccurrenceFrequency
Define the order in which the previous calls are presented.
Conference commands
xCommand Conference DoNotDisturb Activate
This command switches on the Do Not Disturb mode, and the Timeout parameter allows you to
control when it is switched off again. When Do Not Disturb is switched on, all incoming calls are
rejected and registered as missed calls. The calling side receives a busy signal.
Requires user role: ADMIN, USER
USAGE:
xCommand Conference DoNotDisturb Activate [Timeout:
Timeout
]
where
Timeout: Integer (1..1440)
Set the number of minutes before Do Not Disturb is switched off. If not set, Do Not
Disturb times out after 1440 minutes (24 hours).
xCommand Conference DoNotDisturb Deactivate
Switch off the Do Not Disturb mode. When Do Not Disturb is switched off incoming calls come
through as normal.
Requires user role: ADMIN, USER
USAGE:
xCommand Conference DoNotDisturb Deactivate
xCommand Conference SpeakerLock Release
Releases locked speaker set by xCommand Conference SpeakerLock Set. Default voice
switching is switched back on.
Requires user role: ADMIN, USER
USAGE:
xCommand Conference SpeakerLock Release
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus
xCommand