Cisco Cisco DX70 Installation Guide

Date, time and location

(When not set by a provisioning system)
We recommend you check that the date and time settings 

are correct when you set up your video conference system. 

The system uses this information for example to time stamp 

messages transmitted to gatekeepers and other network 

elements.

1.  Go to 

tab and select

. Open the 

settings from the left column.

2.  Select your preferred date format, time format, and  your 

time zone in the corresponding drop down lists. 

3.  Open the 

settings from the left side bar.

4.  Under the 

section select 

,

or

in the 

drop down list.*

a.  If you select 

 enter the NTP server address in 

the 

input field. 

b.  If you select 

, you have to enter the time and date 

manually using either the Touch controller (

) or on the 

command line interface (xCommand Time DateTime 

Set) .

5.  To verify the time settings, go to 

 and click 

. 

Open 

 status from the left side bar. 

* NTP mode: 

Auto: The time is regularly updated using an NTP server. The NTP server 

address is automatically obtained from the network (DHCP). 

Manual: The time is regularly updated using an NTP server. You must 

manually enter the NTP server address. 

Off: You must set the time manually. The time is not updated automatically.

If you are changing a value setting, 

you have to always click 

to confirm the change.

Cisco TelePresence Video Systems

D15318.03 Video Systems Getting Started Guide CE8.2, JUNE 2016. 

Copyright © 2016 Cisco Systems, Inc. All rights reserved. 

18

Getting Started Guide

Introduction

User interfaces

Web interface

Setup assistant

Appendices



Touch

Web interface