Cisco Cisco DX70 Installation Guide
Setup assistant
When you start the system for the first time, the setup assistant
starts automatically
.
Navigate through the setup with either a
remote control or from the touch screen.
To be able to make calls your system needs an IP address
and it needs to be registered to a service. If your system is
automatically provisioned, the IP and provisioning settings
presented in this chapter are automatically configured.
NOTE:
This guide doesn't cover information on Cisco Spark
registered systems. For more information on Cisco Spark
room systems, visit:
Access the settings after initial setup
Select the gearwheel icon in the upper left corner on the home
screen and navigate to
System Information
>
Settings
. Select
the setting you wish to change.
No image on external screen
If the menu doesn't show up on the screen:
• Make sure the screen is connected and has been switched
on.
• Make sure that the correct input is selected on the screen.
• Make sure the remote control has batteries installed.
• Make sure the system is switched on.
• Make sure the remote control has batteries installed.
• Make sure the system is switched on.
If the system has just been switched on, wait a few minutes to
allow the system to start up.
If you still can't see the on-screen menu, make sure the
monitor cable is connected to the video output connector. If in
doubt, see the installation guide for your product.
Cisco TelePresence Video Systems
D15318.03 Video Systems Getting Started Guide CE8.2, JUNE 2016.
Copyright © 2016 Cisco Systems, Inc. All rights reserved.
21
Getting Started Guide
Introduction
User interfaces
Web interface
Setup assistant
Appendices
Touch
Setup assistant