Cisco Cisco DX70 Release Notes

New feature and functionality descriptions CE8.0.0

excessive packet loss. To enable Multistream after a fallback to transcoding the endpoint must end the

call and dial back into the conference.

Note: Multistream is disabled by default on the endpoint.

Note: Multistream requires all required video infrastructure and endpoints to be on the latest

available software.

Note: Bandwidth recommendation for Multistream systems with single screen is 4 Mbps. For

systems with dual screens the bandwidth recommendation is 6 Mbps.

Note: Multistream is currently not supported on SX10. Please see the "Known issues" section in

this document for more information.

Microphone LED behavior changes

After upgrading to Collaboration Endpoint Software the LED surrounding the microphone mute button

on the external microphones and the Cisco TelePresence Touch 10 panel will not glow unless the

system is in, receiving or making a call. Previous behavior of this LED has been a constant glow of

green or red color where green indicates that the microphones are active and red indicates that the

microphones are muted even if the system was not in a call.

The microphone LED will glow and the mute button becomes active in the following scenarios:

When initiating an outgoing call and until the call is disconnected.

When receiving an incoming call and until the call is disconnected.

When activating the VU meter on the web interface to test the audio levels.

The color indications, green for active and red for muted have not changed.

Note: The Cisco TelePresence SX20 Quick Set with PID number CTS-SX20CODEC will not have

this functionality and the microphone LED will still be lit when the system is idle. For SX20 Quick Set

with PID number CTS-SX20NCODEC the microphone LED behavior is aligned with the description

above. The PID number is located on the bottom side of the codec.