Cisco Cisco Content Security Management Appliance M160 User Guide
14-6
AsyncOS 9.6 for Cisco Content Security Management Appliances User Guide
Chapter 14 Common Administrative Tasks
Performing Maintenance Tasks Using CLI Commands
The resetconfig Command
mail3.example.com> suspend
Delay (seconds, minimum 30):
[30]> 45
Waiting for listeners to exit...
Receiving suspended.
Waiting for outgoing deliveries to finish...
Mail delivery suspended.
mail3.example.com> resetconfig
Are you sure you want to reset all configuration values? [N]> Y
All settings have been restored to the factory default.
Displaying the Version Information for AsyncOS
Procedure
Step 1
On the Security Management appliance, choose Management Appliances > Centralized Services >
System Status.
System Status.
Step 2
Scroll to the bottom of the page and look under Version Information to see the version of AsyncOS that
is currently installed.
is currently installed.
Additionally, you can use the version command at the command-line prompt.
To Do
This
•
Reset all configurations to
factory defaults
factory defaults
•
Clear all reporting counters
But
•
Retain log files
•
Retain quarantined messages
1.
Ensure that you can connect to the appliance after reset using
the default admin user account and password, either to the
CLI using the serial interface or to the Management port
using the default settings. See
the default admin user account and password, either to the
CLI using the serial interface or to the Management port
using the default settings. See
for information about accessing an
appliance having default settings.
2.
Suspend service on the appliance.
3.
Select Management Appliance > System Administration >
Configuration File and click Reset.
Configuration File and click Reset.
Note
After resetting, the appliance automatically returns to the
online state. If mail delivery was suspended before reset,
delivery will be attempted again after the reset.
online state. If mail delivery was suspended before reset,
delivery will be attempted again after the reset.
•
Reset all configurations to
factory defaults
factory defaults
•
Remove all data
Use the
diagnostic > reload
CLI command.
Caution
This command is NOT the same as the
similar command used on a Cisco router or
switch.
similar command used on a Cisco router or
switch.