Cisco Cisco MDS 9000 SAN-OS Software Release 1.0 Release Notes
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
8
Cisco MDS 9000 Family Release Notes for Storage Services Interface Image Release 5.0(7)
OL-22148-08
New Features
4.
Enter the following commands:
rmdev -dl <hdisk#> -R (Repeat this for all hdisks.)
cfgmgr
lsdev -Cc disk (See if all the LUNs are discovered.)
lsattr -El <hdisk#> (Check LUN ID field to check that host sees the same LUN ID as the target LUN
ID.)
ID.)
importvg -y <volume group> <hdisk#> (Volume group name is same as the one that was exported
earlier. hdisk# can be just one of the hdisks in the volume group.)
earlier. hdisk# can be just one of the hdisks in the volume group.)
varyonvg <volume group>
mount <file system>
New Features
There are no new features in Cisco MDS SSI Release 5.0(7).
Limitations
This sections lists limitations or restrictions associated with this release.
GUI Support Not Available for Target IO Timeout DVT Configuration
A target IO timeout for DVT can only be configured through the CLI. GUI support for this configuration
is not available in Cisco MDS SSI Release 5.0(7).
is not available in Cisco MDS SSI Release 5.0(7).
A Username Must be Less Than Eighteen Characters
If you enter a SANTap command with a username that is equal to or greater than 18 characters, the error
message “remuser too long” displays, as shown in the following example:
message “remuser too long” displays, as shown in the following example:
switch# sh santap module 8 dvt
remuser too long
The show ivr command and the show zoneset act command complete correctly.
This issue might be seen when you enter SANTap commands on the supervisor module to collect
information from another module.
information from another module.
To work around this issue, do one of the following:
•
Attach to the module and collect the information on the module itself.
•
Use a username with less than 18 characters.