Cisco Cisco IOS Software Release 12.0(22)S
E F T 2 D R A F T - C I S C O C O N F I D E N T I A L
SNMP for Stateful Switchover
debug snmp sync
8
Cisco IOS Release 12.0(22)S
debug snmp sync
To debug Simple Network Management Protocol (SNMP) synchronization and faults in synchronization,
use the debug snmp sync command in privileged EXEC mode. To disable the display of debugging
output, use the no form of this command.
use the debug snmp sync command in privileged EXEC mode. To disable the display of debugging
output, use the no form of this command.
debug snmp sync
no debug snmp sync
Syntax Description
This command has no arguments or keywords.
Defaults
Disabled
Command Modes
Privileged EXEC
Command History
Usage Guidelines
The debug snmp sync command can be used to debug SNMP synchronization and faults in
synchronization. The standby Route Processor (RP) may sometimes reset as a result of synchronization
faults. If the fault occurs when SNMP activities such as SNMP sets are in progress, enter the debug
snmp sync command to identify whether a synchronization fault caused the reset.
synchronization. The standby Route Processor (RP) may sometimes reset as a result of synchronization
faults. If the fault occurs when SNMP activities such as SNMP sets are in progress, enter the debug
snmp sync command to identify whether a synchronization fault caused the reset.
SNMP synchronizations (dynamic and bulk) are performed only if the router is configured to be in
stateful switchover (SSO) mode.
stateful switchover (SSO) mode.
Examples
The following example enables debugging of SNMP synchronization activity:
router> debug snmp sync
Related Commands
Release
Modification
12.0(22)S
This command was introduced.
Command
Description
debug snmp packets
Displays information about every SNMP packet sent or received by the
networking device.
networking device.
mode
Configures the redundancy mode of operation.