Cisco Cisco ISA550W Integrated Security Appliance Release Note
3
Release Notes
Known Issues
The following table lists the known issues in version 1.1.13 . As with any upgrade,
review these known issues before upgrading the firmware.
review these known issues before upgrading the firmware.
Reference
Number
Number
Issue
CSCua43844
The Usage Report may display the public IP addresses
instead of the private IP addresses on the LAN. Typically
this issue occurs after topology changes, especially for
WAN Interfaces.
instead of the private IP addresses on the LAN. Typically
this issue occurs after topology changes, especially for
WAN Interfaces.
CSCuc40174
Interaction between Spanning Tree Protocol (STP) and
Cisco Discovery Protocol (CDP) can cause a traffic
outage when STP blocks a port due to a physical loop in
the network.
Cisco Discovery Protocol (CDP) can cause a traffic
outage when STP blocks a port due to a physical loop in
the network.
Work Around: Remove the physical loop, or disable STP,
CDP, or both features.
CDP, or both features.
CSCuc47788
The Bandwidth Usage Report by IP Address displays the
server’s public IP address instead of the SSLVPN client’s
IP address.
server’s public IP address instead of the SSLVPN client’s
IP address.
CSCuc89697
Sometimes a mobile phone using AnyConnect Mobile
Client loses connectivity.
Client loses connectivity.
CSCud06033
When the VRRP priority is changed, the update is not sent
to the PC. For example, after adjusting the priority to
make one router act as a backup, both routers may act as
the master.
to the PC. For example, after adjusting the priority to
make one router act as a backup, both routers may act as
the master.
Work Around: Disable STP.
CSCud10160
UPNP processes may cause the CPU to run at 100%.
Work Around: Open the Device Management >
Discovery Protocols > UPnP page, disable UPnP, and then
enable it again.
Discovery Protocols > UPnP page, disable UPnP, and then
enable it again.
CSCub91801
With AnyConnect 3.1.00496 or above releases, SSL VPN
connection may fail during MTU renegotiation.
connection may fail during MTU renegotiation.
Work Around: Change the MTU size to default value of
1500 on the PC.
1500 on the PC.