Intel Core™2 Extreme Processor QX6800 (8M Cache, 2.93 GHz, 1066 MHz FSB) HH80562XH0778M Data Sheet

Datasheet

35

The processor may contain components on the substrate that define component keep-

out zone requirements. A thermal and mechanical solution design must not intrude into 

the required keep-out zones. Decoupling capacitors are typically mounted to either the 

topside or land-side of the package substrate. See 

 for keep-out 

zones. The location and quantity of package capacitors may change due to 

manufacturing efficiencies but will remain within the component keep-in.

 provides dynamic and static load specifications for the processor package. 

These mechanical maximum load limits should not be exceeded during heatsink 

assembly, shipping conditions, or standard use condition. Also, any mechanical system 

or component testing should not exceed the maximum limits. The processor package 

substrate should not be used as a mechanical reference or load-bearing surface for 

thermal and mechanical solution. The minimum loading specification must be 

maintained by any thermal and mechanical solutions.

.

 includes a list of guidelines on package handling in terms of recommended 

maximum loading on the processor IHS relative to a fixed substrate. These package 

handling loads may be experienced during heatsink removal.

Static

80 N [17 lbf]

311 N [70 lbf]

1, 2, 3

1.

These specifications apply to uniform compressive loading in a direction normal to the

processor IHS.

2.

This is the maximum force that can be applied by a heatsink retention clip. The clip must also

provide the minimum specified load on the processor package.

3.

These specifications are based on limited testing for design characterization. Loading limits are

for the package only and do not include the limits of the processor socket.

Dynamic

—

756 N [170 lbf]

4.

Dynamic loading is defined as an 11 ms duration average load superimposed on the static load

requirement.

Shear

311 N [70 lbf]

1, 2

1.

A shear load is defined as a load applied to the IHS in a direction parallel to the IHS top surface.

2.

These guidelines are based on limited testing for design characterization.

Tensile

111 N [25 lbf]

3.

A tensile load is defined as a pulling load applied to the IHS in a direction normal to the IHS

surface.

Torque

3.95 N-m [35 lbf-in]

4.

A torque load is defined as a twisting load applied to the IHS in an axis of rotation normal to the

IHS top surface