Cisco Cisco ASA 5580 Adaptive Security Appliance Leaflet
11-25
思科 ASA 系列命令参考,S 命令
第 11 章 show pager 至 show route 命令
show port-channel
Port-channel = Po1
Flags: S - Device is sending Slow LACPDUs F - Device is sending fast LACPDUs.
A - Device is in active mode. P - Device is in passive mode.
Local information:
LACP port Admin Oper Port Port
Port Flags State Priority Key Key Number State
-----------------------------------------------------------------------------
Gi3/2 SA bndl 32768 0x1 0x1 0x303 0x3d
Partner's information:
Partner Partner LACP Partner Partner Partner Partner Partner
Port Flags State Port Priority Admin Key Oper Key Port Number Port State
-----------------------------------------------------------------------------------
Gi3/2 SA bndl 32768 0x0 0x1 0x303 0x3d
Port: Gi3/3
------------
Port state = bndl
Channel group = 1 Mode = LACP/ active
Port-channel = Po1
Flags: S - Device is sending Slow LACPDUs F - Device is sending fast LACPDUs.
A - Device is in active mode. P - Device is in passive mode.
Local information:
LACP port Admin Oper Port Port
Port Flags State Priority Key Key Number State
-----------------------------------------------------------------------------
Gi3/3 SA bndl 32768 0x1 0x1 0x304 0x3d
Partner's information:
Partner Partner LACP Partner Partner Partner Partner Partner
Port Flags State Port Priority Admin Key Oper Key Port Number Port State
-----------------------------------------------------------------------------------
Gi3/3 SA bndl 32768 0x0 0x1 0x302 0x3d
以下是
show port-channel protocol 命令的输出示例:
ciscoasa# show port-channel protocol
Channel-group listing:
-----------------------
Group: 1
----------
Protocol: LACP
相关命令
命令
说明
channel-group
将接口添加到
EtherChannel。
interface port-channel
配置
EtherChannel。
lacp max-bundle
指定通道组中允许的最大主用接口数。
lacp port-priority
为通道组中的物理接口设置优先级。
lacp system-priority
设置
LACP 系统优先级。
port-channel load-balance
配置负载平衡算法。
port-channel min-bundle
指定端口通道接口变成主用接口所需的最小主用接口数。