Cisco Cisco ASA 5510 Adaptive Security Appliance Leaflet
7-11
Cisco ASA Series 명령 참조, S 명령
7장 show failover through show ipsec stats traffic 명령
show failover
각 상태 변경에는 상태 변경 사유가 뒤따릅니다. 사유는 일반적으로 디바이스가 일시적인 상태에
서 안정적인 상태로 진행될 때 동일하게 유지됩니다. 가능한 상태 변경 사유는 다음과 같습니다.
서 안정적인 상태로 진행될 때 동일하게 유지됩니다. 가능한 상태 변경 사유는 다음과 같습니다.
•
No Error
•
Set by the CI config cmd
•
Failover state check
•
Failover interface become OK
•
HELLO not heard from mate
•
Other unit has different software version
•
Other unit operating mode is different
•
Other unit license is different
•
Other unit chassis configuration is different
•
Other unit card configuration is different
•
Other unit want me Active
•
Other unit want me Standby
•
Other unit reports that I am failed
•
Other unit reports that it is failed
•
Configuration mismatch
•
Detected an Active mate
•
No Active unit found
•
Configuration synchronization done
•
Recovered from communication failure
•
Other unit has different set of vlans configured
•
Unable to verify vlan configuration
•
Incomplete configuration synchronization
•
Configuration synchronization failed
•
Interface check
•
My communication failed
•
ACK not received for failover message
•
Other unit got stuck in learn state after sync
•
No power detected from peer
•
No failover cable
•
HA state progression failed
•
Detect service card failure
•
Service card in other unit has failed
•
My service card is as good as peer
•
LAN Interface become un-configured
•
Peer unit just reloaded
•
Switch from Serial Cable to LAN-Based fover