Cisco Cisco ASA 5510 Adaptive Security Appliance Leaflet

Cisco ASA Series 명령 참조, S 명령      

7장      show failover through show ipsec stats traffic 명령

다음은 ASA 5505에서 실행된 show interface 명령의 샘플 출력입니다(스위치 포트 포함).

ciscoasa# show interface

Interface Vlan1 "inside", is up, line protocol is up

  Hardware is EtherSVI, BW 100 Mbps, DLY 100 usec

        MAC address 00d0.2bff.449f, MTU 1500

        IP address 1.1.1.1, subnet mask 255.0.0.0

  Traffic Statistics for "inside":

        0 packets input, 0 bytes

        0 packets output, 0 bytes

        0 packets dropped

      1 minute input rate 0 pkts/sec,  0 bytes/sec

      1 minute output rate 0 pkts/sec,  0 bytes/sec

      1 minute drop rate, 0 pkts/sec

      5 minute input rate 0 pkts/sec,  0 bytes/sec

      5 minute output rate 0 pkts/sec,  0 bytes/sec

      5 minute drop rate, 0 pkts/sec

    Interface Ethernet0/0 "", is up, line protocol is up

      Hardware is 88E6095, BW 100 Mbps, DLY 1000 usec

            Auto-Duplex(Half-duplex), Auto-Speed(100 Mbps)

            Available but not configured via nameif

            MAC address 00d0.2bfd.6ec5, MTU not set

            IP address unassigned

            407 packets input, 53587 bytes, 0 no buffer

            Received 103 broadcasts, 0 runts, 0 giants

            0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

            0 L2 decode drops

            43 switch ingress policy drops

            0 packets output, 0 bytes, 0 underruns

            0 output errors, 0 collisions, 0 interface resets

            0 babbles, 0 late collisions, 0 deferred

            0 lost carrier, 0 no carrier

            0 rate limit drops

            0 switch egress policy drops