Cisco Cisco ASA 5510 Adaptive Security Appliance Leaflet
7-51
Cisco ASA Series 명령 참조, S 명령
7장 show failover through show ipsec stats traffic 명령
show interface
Interface state is active
Interface Internal-Data0/0 "", is up, line protocol is up
Hardware is i82547GI rev00, BW 1000 Mbps, DLY 1000 usec
(Full-duplex), (1000 Mbps)
MAC address 0000.0001.0002, MTU not set
IP address unassigned
6 packets input, 1094 bytes, 0 no buffer
Received 6 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 L2 decode drops, 0 demux drops
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions
0 late collisions, 0 deferred
input queue (curr/max packets): hardware (0/2) software (0/0)
output queue (curr/max packets): hardware (0/0) software (0/0)
Control Point Interface States:
Interface number is unassigned
...
에는 show interface detail 명령의 각 필드에 대한 설명이 나와 있습니다. show interface 명
을 참고하십시오.
표
7-7
show interface detail
필드
필드
설명
Demux drops
(내부 데이터 인터페이스에만 해당) ASA가 SSM 인터페이스의 패킷을 역다
중화할 수 없어 삭제된 패킷 수입니다. SSM 인터페이스는 백플레인을 통해
기본 인터페이스와 통신하며, 모든 SSM 인터페이스의 패킷은 백플레인에서
다중화됩니다.
중화할 수 없어 삭제된 패킷 수입니다. SSM 인터페이스는 백플레인을 통해
기본 인터페이스와 통신하며, 모든 SSM 인터페이스의 패킷은 백플레인에서
다중화됩니다.
Control Point
Interface States:
Interface States:
Interface
number
number
0에서 시작하여 이 인터페이스가 생성된 순서를 나타내는 디버깅용 번호입
니다.
니다.
Interface
config status
config status
다음과 같은 관리 상태입니다.
•
active - 인터페이스가 종료되지 않았습니다.
•
not active - shutdown 명령을 통해 인터페이스가 종료되었습니다.
Interface state
인터페이스의 실제 상태입니다. 대부분의 경우 이 상태는 위의 config status와
일치합니다. 고가용성을 구성한 경우 ASA에서 필요에 따라 인터페이스를 작
동하거나 중단하기 때문에 불일치가 발생할 수 있습니다.
일치합니다. 고가용성을 구성한 경우 ASA에서 필요에 따라 인터페이스를 작
동하거나 중단하기 때문에 불일치가 발생할 수 있습니다.
Asymmetrical
Routing Statistics:
Routing Statistics:
Received X1
packets
packets
이 인터페이스에서 수신된 ASR 패킷 수입니다.
Transmitted
X2 packets
X2 packets
이 인터페이스에서 전송된 ASR 패킷 수입니다.
Dropped X3
packets
packets
이 인터페이스에서 삭제된 ASR 패킷 수입니다. 패킷을 전달하려고 할 때 인
터페이스의 작동이 중지된 경우 패킷이 삭제될 수 있습니다.
터페이스의 작동이 중지된 경우 패킷이 삭제될 수 있습니다.