Cisco Cisco ASA 5510 Adaptive Security Appliance Leaflet

7-52

Cisco ASA Series 명령 참조 , S 명령

7장 show failover through show ipsec stats traffic 명령

show interface

다음은 ASA 5512-X~ASA 5555-X에서 실행된 show interface detail 명령의 샘플 출력입니다. 이 예
에서는 ASA 및 소프트웨어 모듈 둘 다에 대한 Management 0/0 인터페이스(“Internal-Data0/1”로 표
시)의 통합 통계를 보여 줍니다. 또한 소프트웨어 모듈과 ASA 간의 제어 트래픽에 사용되는
Internal-Control0/0 인터페이스도 출력에 표시되어 있습니다.

Interface Internal-Data0/1 "ipsmgmt", is down, line protocol is up

Hardware is , BW Unknown Speed-Capability, DLY 1000 usec

(Full-duplex), (1000 Mbps)

Input flow control is unsupported, output flow control is unsupported

MAC address 0100.0100.0000, MTU not set

IP address 127.0.1.1, subnet mask 255.255.0.0

0 packets input, 0 bytes, 0 no buffer

Received 0 broadcasts, 0 runts, 0 giants

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

0 pause input, 0 resume input

0 L2 decode drops

182 packets output, 9992 bytes, 0 underruns

0 pause output, 0 resume output

0 output errors, 0 collisions, 0 interface resets

0 late collisions, 0 deferred

0 input reset drops, 0 output reset drops

input queue (blocks free curr/low): hardware (0/0)

output queue (blocks free curr/low): hardware (0/0)

Traffic Statistics for "ipsmgmt":

0 packets input, 0 bytes

0 packets output, 0 bytes

0 packets dropped

1 minute input rate 0 pkts/sec, 0 bytes/sec

1 minute output rate 0 pkts/sec, 0 bytes/sec

1 minute drop rate, 0 pkts/sec

5 minute input rate 0 pkts/sec, 0 bytes/sec

5 minute output rate 0 pkts/sec, 0 bytes/sec

5 minute drop rate, 0 pkts/sec

Control Point Interface States:

Interface number is 11

Interface config status is active

Interface state is active

Interface Internal-Control0/0 "cplane", is down, line protocol is up