Cisco SSL Appliance 8200 Technical Manual
Configuration of SNMP on an SSL Appliance
Document ID: 118665
Contributed by Nazmul Rajib and Jose Escobar, Cisco TAC Engineers.
Nov 17, 2014
Nov 17, 2014
Contents
Introduction
Prerequisites
Component Used
Requirement
Configuration
Prerequisites
Component Used
Requirement
Configuration
Introduction
You can enable Simple Network Management Protocol (SNMP) on an SSL appliance. The SSL Appliance
models 1500, 2000 and 8200 support the standard SNMP MIB2 tables, and use the SNMP v2c version of the
protocol. This document provides you the steps to enable SNMP on an SSL Appliance.
models 1500, 2000 and 8200 support the standard SNMP MIB2 tables, and use the SNMP v2c version of the
protocol. This document provides you the steps to enable SNMP on an SSL Appliance.
Prerequisites
Component Used
The following components have been used on this document:
SSL appliances 1500, 2000, 8200
•
Software Version 3.6 or greater
•
Requirement
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Configuration
You can configure SNMP on an SSL Appliance using the web user interface of the appliance. The steps are:
1. Navigate to the Platform Management menu and select Management Network.
Note: The platform management menu shows the hostname of SSL appliance. In this example, it is cisco.