Cisco Cisco 3365 Mobility Services Engine Data Sheet

Page of 5
 
 
© 2015 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. 
Page 4 of 5 
Table 2. 
Cisco MSE License SKUs 
Base Location 
License SKU 
CMX License SKU 
Upgrade License 
from Base Location 
to CMX 
wIPS Monitor Mode/ 
Monitor 
Module SKUs 
wIPS Enhanced 
Local Mode SKUs 
Description 
L-LS-1AP 
L-AD-LS-1AP 
L-UPG-LS-1AP 
L-WIPS-MM-1AP 
L-WIPS-ELM-1AP 
Supports 1 access 
point 
L-LS-100AP 
L-AD-LS-100AP 
L-WIPS-MM-100AP 
L-WIPS-ELM-100AP 
Supports 100 access 
points 
L-LS-1000AP 
L-AD-LS-1000AP 
L-WIPS-MM-1000AP 
L-WIPS-ELM-1000AP  Supports 1000 access 
points 
Cisco Mobility Services Licenses for High Availability 
For high-availability deployments, two physical or virtual appliances are required, but only one set of licenses is 
required to be installed on the primary appliance. Note that if using the vMSE, both virtual appliances require an 
activation license (L-MSE-7.0-K9). For detailed design and scaling information, please see the CMX Configuration 
Guide at 
. 
Ordering Support for Physical and Virtual Appliances 
Select the appropriate level of support. Table 3 lists the Cisco MSE support SKUs. 
Note:   If ordering the MSE 3355 or vMSE, a single service SKU covers both hardware as well as software 
support. If ordering the MSE 3365 appliance, hardware support and software support must be ordered separately. 
Table 3. 
Cisco MSE Support SKUs 
MSE Model 
SKU 
Service SKU 
Description 
MSE 3365 physical appliance 
AIR-MSE-3365-K9 
CON-SNT-AIRMSE3K 
Hardware and software support 
MSE 3355 physical appliance 
AIR-MSE-3355-K9 
CON-SNT-MSE3355 
Hardware and software support 
MSE virtual appliance 
L-MSE-7.0-K9  
CON-SAU-LMSE7K 
Software and software support 
MSE 8.0 Base License 
L-LS-xAP 
CON-SAU-LLS1APSW 
Software support (only if ordering the 3365 
appliance) 
MSE 8.0 CMX License 
L-AD-LS-xAP 
CON-SAU-LADLA1AP 
Software support (only if ordering the 3365 
appliance) 
Ordering FastLocate 
FastLocate increases the location update rate for all the associated devices. FastLocate requires a 
 (WSM) on every access point that participates in the location calculation. In addition, the MSE 
requires either a Base Location or CMX license for every access point. 
Ordering MSE Licenses for Legacy Software Versions 
Prior to the 7.4 software release, the MSE licensing scheme was based on the number of tracked end devices. The 
current scheme is based on the number of WLAN access points. 
The legacy end-device licenses are still orderable for MSEs using software up to and including the 7.3 release. The 
SKU is under L-MSE-PAK. Table 4 shows the SKUs for these licenses.