Cisco Cisco 3365 Mobility Services Engine Release Notes

Use the BST to view the details of a caveat listed in this section. For more information about the BST, 
see the 

Cisco MSE displays unknown error when importing AP from Prime Infrastructure

Cisco MSE version 8.0.110.0 crashed due to an OutOfMemory error.

Cisco MSE Client count and interferer count reaches the maximum and then never 
drops.

Cisco MSE crash at locserver with outofMemoryHeapDump.

Cisco MSE does not show active clients when Cisco Aironet 1702 Access Points are 
added to map.

Thread lock observed when 25k clients were synced to Cisco MSE.

After full Linux reboot of secondary service HA sync-up does not complete.

CMX Connect: Client does not connect to right splash page between floor.

Eth connect and disconnect on primary does not resync HA at times.

HA re-sync takes an hour on primary/standby disconnect.

HA sync failed because standby database is not mounted.

HA sync status on setup failed even if the pairing goes well in back-end.

Initial Cisco MSE HA paring fails.

Cisco MSE failback fails from secondary to primary at times.

Cisco MSE HA config fails in the last step.

Cisco MSE has high latency and high pending calculations.

When the pkill java command is executed on the primary Cisco MSE server in the 
middle of replication, it breaks HA failback.

Primary Cisco MSE goes down in a day after the secondary Cisco MSE goes down.

Secondary Cisco MSE in HA unable to failback to primary at one instance.

Secondary stops communicating with primary when backup runs on primary.

Compress the wIPS profile before sending to controller.

Fragment the wIPS profile before passing on to CAPWAP process.

HA failover happens after database process limit reached.

Database goes down with lots of dumps in the incident folder.

wIPS server running out of memory.

Cisco MSE 8.0.120.0: Analytics reports gives error session expired for 3 out of 6 
options.