Cisco Cisco 2000 Series Wireless LAN Controller Release Notes
4
Release Notes for Cisco Wireless LAN Controller and Cisco Lightweight Access Point for Release 3.1.105.0
OL-7431-03
Installation Notes
Warning
This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that
the protective device is rated not greater than:
120 VAC, 15A U.S. (240vac, 10A International)
the protective device is rated not greater than:
120 VAC, 15A U.S. (240vac, 10A International)
Warning
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground connector. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available.
absence of a suitably installed ground connector. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available.
Warning
Read the installation instructions before you connect the system to its power source.
Warning
Do not work on the system or disconnect cables during periods of lightning activity.
Warning
Do not operate your wireless network near unshielded blasting caps or in an explosive environment
unless the device has been modified to be especially qualified for such use.
unless the device has been modified to be especially qualified for such use.
Warning
In order to comply with radio frequency (RF) exposure limits, the antennas for this product should be
positioned no less than 6.56 ft. (2 m) from your body or nearby persons.
positioned no less than 6.56 ft. (2 m) from your body or nearby persons.
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security.
accessed only through the use of a special tool, lock and key, or other means of security.
Safety Information
Follow the guidelines in this section to ensure proper operation and safe use of the Wireless LAN
Controllers and Cisco lightweight access points.
Controllers and Cisco lightweight access points.
FCC Safety Compliance Statement
FCC Compliance with its action in ET Docket 96-8, has adopted a safety standard for human exposure
to RF electromagnetic energy emitted by FCC-certified eqipment. When used with approved Cisco
Aironet antennas, Cisco Aironet products meet the uncontrolled environmental limits found in OET-65
and ANSI C95.1, 1991. Proper operation of this radio device according to the instructions in this
publication results in user exposure substantially below the FCC recommended limits.
to RF electromagnetic energy emitted by FCC-certified eqipment. When used with approved Cisco
Aironet antennas, Cisco Aironet products meet the uncontrolled environmental limits found in OET-65
and ANSI C95.1, 1991. Proper operation of this radio device according to the instructions in this
publication results in user exposure substantially below the FCC recommended limits.