Cisco Cisco 4402 Wireless LAN Controller Release Notes
8
Release Notes for Cisco Wireless LAN Controllers and Lightweight Access Points for Release 4.0.217.0
OL-31336-01
Important Notes
Re-enable Broadcast after Upgrading to Release 4.0.206 or Later
In software releases 4.0.179 and earlier, broadcast and multicast forwarding were both controlled with
a single global flag that enabled multicast. In software release 4.0.206 these functions were broken into
separate configuration flags: one that contols broadcast and one that controls non-broadcast multicast.
If you have multicast enabled in software releases 4.0.179 and earlier, the broadcast flag is left disabled
after upgrading to software release 4.0.206. As a result, some applications that rely on broadcast do not
work after the upgrade.
a single global flag that enabled multicast. In software release 4.0.206 these functions were broken into
separate configuration flags: one that contols broadcast and one that controls non-broadcast multicast.
If you have multicast enabled in software releases 4.0.179 and earlier, the broadcast flag is left disabled
after upgrading to software release 4.0.206. As a result, some applications that rely on broadcast do not
work after the upgrade.
After you upgrade to software release 4.0.206.0 or later, use this CLI command to re-enable broadcast:
config network broadcast enable
When re-enabled, broadcast uses the multicast mode configured on the controller. If you want to turn on
broadcast only and set it to another multicast mode you must use the CLI because the GUI configuration
forces multicast on.
broadcast only and set it to another multicast mode you must use the CLI because the GUI configuration
forces multicast on.
Service Modules Supported in the Catalyst 6500 Series Switch
The Catalyst 6500 Series Switch chassis can support up to five Cisco WiSMs without any other service
module installed. If one or more service modules are installed, the chassis can support up to a maximum
of four service modules (WiSMs included).
module installed. If one or more service modules are installed, the chassis can support up to a maximum
of four service modules (WiSMs included).
Connecting 1100 and 1300 Series Access Points
You must install software release 4.0.179.8 or later on the controller before connecting 1100 and 1300
series access points to the controller.
series access points to the controller.
Association Delay for 1500 Series Access Points
The 1500 series access points may take up to 10 minutes to fully associate to the controller on initial
startup.
startup.
Controllers Must Run Release 3.2.116.21 or Later to Support -P Regulatory
Domain
Domain
To support access points configured for use in Japan, you must upgrade the controller software to release
3.2.116.21 or later. Earlier releases do not support access points configured for use in Japan (regulatory
domain -P).
3.2.116.21 or later. Earlier releases do not support access points configured for use in Japan (regulatory
domain -P).
Preventing Clients from Accessing the Management Network on a Controller
To prevent or block a wired or wireless client from accessing the management network on a controller
(from the wireless client dynamic interface or VLAN), the network administrator should ensure that
there is no route through which to reach the controller from the dynamic interface or use a firewall
between the client dynamic interface and the management network.
(from the wireless client dynamic interface or VLAN), the network administrator should ensure that
there is no route through which to reach the controller from the dynamic interface or use a firewall
between the client dynamic interface and the management network.