Cisco Cisco Email Security Appliance X1070 User Guide
3-19
Cisco IronPort AsyncOS 7.5 for Email Configuration Guide
OL-25136-01
Chapter 3 Setup and Installation
Using the System Setup Wizard
The Cisco IronPort AsyncOS operating system provides a browser-based System
Setup Wizard to guide you through the five step process of system configuration.
Also included is a command line interface (CLI) version of the System Setup
Wizard. See
Setup Wizard to guide you through the five step process of system configuration.
Also included is a command line interface (CLI) version of the System Setup
Wizard. See
for more information. Some users will want to take advantage of
custom configuration options not available in the System Setup Wizard. However,
you must use the System Setup Wizard for the initial setup to ensure a complete
configuration. If you have gathered the information required in
you must use the System Setup Wizard for the initial setup to ensure a complete
configuration. If you have gathered the information required in
, the configuration process will take less time to complete.
Warning
The System Setup Wizard will completely reconfigure your system. You should
only use the System Setup Wizard the very first time you install the appliance,
or if you want to completely overwrite your existing configuration.
only use the System Setup Wizard the very first time you install the appliance,
or if you want to completely overwrite your existing configuration.
Warning
The Cisco IronPort appliance ships with a default IP address of
192.168.42.42
on the Management port of C60/600/650/660/670, C30/300/350/360/370, and
X1000/1050/1060/1070 systems, and the Data 1 port of C10/100/150/160 systems.
Before connecting the Cisco IronPort appliance to your network, ensure that no
other device’s IP address conflicts with this factory default setting. If you are
configuring a Cisco IronPort M-Series appliance, please see
X1000/1050/1060/1070 systems, and the Data 1 port of C10/100/150/160 systems.
Before connecting the Cisco IronPort appliance to your network, ensure that no
other device’s IP address conflicts with this factory default setting. If you are
configuring a Cisco IronPort M-Series appliance, please see
.
If you are connecting multiple factory-configured Cisco IronPort appliances to
your network, add them one at a time, reconfiguring each Cisco IronPort
appliance’s default IP address as you go.
your network, add them one at a time, reconfiguring each Cisco IronPort
appliance’s default IP address as you go.
McAfee Anti-Virus Scanning Engine
Enable / Disable
Sophos Anti-Virus Scanning Engine
Enable / Disable
Outbreak Filters
Enable / Disable
Table 3-4
System Setup Worksheet: 1 IP Address for All Email Traffic