Cisco Cisco NAC Appliance 4.9.1 Installation Guide
42
Manually Restarting the Configuration Utility
If after installation you need to reset the configuration settings, or if you need to start the configuration
utility manually, you can issue the
utility manually, you can issue the
service perfigo config
CLI command on either the Clean Access
Server or Clean Access Manager. When using
service perfigo config
, you will also need to enter
service perfigo reboot
after configuration is complete to reboot the machine.
Step 1
Connect to the CAS or CAM through direct console connection, serial connection, or SSH.
Step 2
Login as user:
root
, password:
cisco123
(default).
Step 3
Run the following command:
service perfigo config
Step 4
Accept the default values or provide new ones for all prompts (as described in Running the
Configuration Utility, page 31).
Configuration Utility, page 31).
Step 5
When configuration is done, enter
service perfigo reboot
to reboot the machine.
Powering Down the NAC Appliance
To power down the CAM/CAS, use one of the following recommended methods while connected via
console/SSH. These methods prevent database corruption when powering down the CAM.
console/SSH. These methods prevent database corruption when powering down the CAM.
•
Type
service perfigo stop
and power down the machine.
•
Type
/sbin/halt
and power down the machine.
7
Accessing the CAM Web Console
The Clean Access Manager web administration console is the primary interface for administering the
Cisco NAC Appliance deployment. After initial configuration is complete, use the following steps to
access the CAM web console.
Cisco NAC Appliance deployment. After initial configuration is complete, use the following steps to
access the CAM web console.
Step 1
Launch a web browser from a computer accessible to the CAM by network. (Microsoft
Internet Explorer 6.0 and 7.0 are supported.)
Internet Explorer 6.0 and 7.0 are supported.)
Step 2
In the URL/address field, type the IP address of the CAM (or the host name if you have made
the required entry in your DNS server).
the required entry in your DNS server).
Step 3
If using a temporary SSL certificate, the security alert appears and you are prompted to accept
the certificate. Click Yes to accept the certificate. (If using signed certificates, security dialogs
will not appear.)
the certificate. Click Yes to accept the certificate. (If using signed certificates, security dialogs
will not appear.)