Cisco Cisco NAC Appliance 4.9.1 Technical Manual
NAC (Clean Access): Configure Guest Access
Document ID: 107496
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Types of Guest Access
Configure Single Guest Button
Configure Local User Guest Account
External Guest Portal through API
Related Information
Prerequisites
Requirements
Components Used
Conventions
Types of Guest Access
Configure Single Guest Button
Configure Local User Guest Account
External Guest Portal through API
Related Information
Introduction
This document describes how to configure the various types of guest access on the Cisco Clean Access or
NAC appliance with the Clean Access Manager (CAM).
NAC appliance with the Clean Access Manager (CAM).
Prerequisites
Requirements
This configuration is applicable to CAM version 3.5 and later.
Components Used
The information in this document is based on CAM version 4.1.
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Conventions
Refer to the Cisco Technical Tips Conventions for more information on document conventions.
Types of Guest Access
There are three main types of guest access:
Single Guest Button
Allows guest access through a single Guest button.
♦
Provides Acceptable User Page to Accept/Deny.
♦
Provides policy, bandwidth and session/inactivity controls.
♦
Does not log individual guest usernames.
♦
Does not prevent guest relogin/reuse.
♦
•