Cisco Cisco NAC Appliance 4.9.4 Technical Manual

Introduction
 Prerequisites
      Requirements
      Components Used
      Conventions
 Configure
      Network Diagram
      Configure Authentication on CCA with ACS 5.x
      ACS5.x Configuration
 Troubleshoot
 Related Information

This document provides information how to configure authentication on the Clean Access Manager (CAM)
with Cisco Secure Access Control System (ACS) 5.x and later. For a similar configuration using versions
earlier than ACS 5.x, refer to NAC (CCA): Configure Authentication on the Clean Access Manager (CAM)
with ACS.

This configuration is applicable to CAM version 3.5 and later.

The information in this document is based on CAM version 4.1.

The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.

Refer to the Cisco Technical Tips Conventions for more information on document conventions.

In this section, you are presented with the information to configure the features described in this document.

Note: Use the Command Lookup Tool (registered customers only) to obtain more information on the
commands used in this section.