Cisco Cisco SG300-28 28-Port Gigabit Managed Switch Technical References
IP Addressing Commands
592
78-20269-01 Command Line Interface Reference Guide
37
Default
Enabled by default.
Command Mode
Global Configuration mode
User Guidelines
This command overrides any proxy ARP interface configuration. To use this
command, you must put the switch into router mode using
command, you must put the switch into router mode using
set system mode
.
Example
The following example globally disables ARP proxy when the switch is in router
mode.
mode.
switchxxxxxx(config)#
ip arp proxy disable
37.9
ip proxy-arp
Use the ip proxy-arp Interface Configuration mode command to enable an ARP
proxy on specific interfaces. Use the no form of this command disable it.
proxy on specific interfaces. Use the no form of this command disable it.
This command can only be used when the device is in Router mode.
Syntax
ip proxy-arp
no ip proxy-arp
Default Configuration
ARP Proxy is disabled.
Command Mode
Interface Configuration (Ethernet, VLAN, Port-channel) mode. It cannot be
configured for a range of interfaces (range context).
configured for a range of interfaces (range context).