Cisco Cisco SF200-24P 24-Port 10 100 PoE Smart Switch Release Notes

Release Notes for 200, 300, 500, and ESW2 Series Switches Firmware Version 1.4.5.02

7

To determine which version of hardware you are using, click Status > System 
Summary. Look at the lower portion of the screen under the graphic 
representation of the switch for the PID VID. The descriptor will end in the VID 
number. The version information is also shown on the product label on the back of 
the switch. The PID VID is located at the bottom of the label.

In versions 1.3.5 and later, the Flash file system has been upgraded. This has 
implications when upgrading from previous releases to version 1.3.5, and when 
downgrading from 1.3.5 or later to previous versions as described below. 

When upgrading the device from version prior to 1.3.5:

•

For Sx200/Sx300 models, first upgrade the device image to image version 
1.3.5.x and upgrade the boot file to 1.3.5.06

•

For Sx500 models, first upgrade the device image to image version 1.3.7.x 
and upgrade the boot file to 1.3.7.01

During the first bootup of the new image version (1.3.5.x or 1.3.7.x), the flash file 
system is upgraded and:

•

This process takes a few minutes. "…" progress in the Console is displayed 
during this process (not relevant to Sx200).

Sx300 in Firmware 1.1.x 
and above. 
HW VID=01

8K

256

256

Sx300 in Firmware 1.1.x 
and above.
HW VID=02

16K

4K

1K

Sx500, SG500X and ESW2 switches have a single version of HW, see the 
admin guide for details.