Cisco Cisco Packet Data Gateway (PDG) Troubleshooting Guide
Exec Modes Show Commands (H-L)
▀ show ip
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
: Lists the entries for a specified prefix list.
must be a string of from 1
through 79 alpha and/or numeric characters.
: Lists summary information for all prefix lists and their entries. If a list name is
specified only the summary for the specified prefix list are displayed.
must be a string of from 1
through 79 alpha and/or numeric characters.
Displays general RIP routing process information. (RIP is not supported at this time.)
Indicates the route information to the address specified by
is to be displayed. The
route gateway address may be specified as needed to identify the route.
and
must be specified using the standard IPv4 dotted decimal notation.
Displays the static route information for the address specified by
is to be displayed.
The static route gateway address may also be specified to identify the route.
and
must be specified using the standard IPv4 dotted decimal notation.
Displays the routing information of the VRF.
a name used to identify a VRF.
Indicates the output of the command is to be piped (sent) to the command specified. A command to send
output to must be specified.
For details on the usage of
output to must be specified.
For details on the usage of
and
, refer to the Regulating a Command’s Output section of the
Command Line Interface Overview chapter in the Command Line Interface Reference.
Usage
Show the IP information to verify and/or troubleshooting communication difficulties between to a remote
host/node.
host/node.
Example
The following command displays the ACL for the list named
The following command displays the ACL for the list named
.
The following command will output the static route information to remote host
.