Cisco Cisco Packet Data Gateway (PDG) Troubleshooting Guide
GTPP Server Group Configuration Mode Commands
▀ gtpp data-request sequence-numbers
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
gtpp data-request sequence-numbers
Configures the range of sequence numbers to be used in the GTPP data record transfer record (DRT). Use this command
to set the start value for the sequence number.
to set the start value for the sequence number.
Product
GGSN, SGSN
Privilege
Security Administrator, Administrator
Syntax
Default is 0 (zero).
Specifies the value of the start sequence number for the GTPP Data Record Transfer Request. Default: 0
0 = Designates the start sequence number as 0.
1 = Designates the start sequence number as 1.
Usage
When the GGSN/SGSN is configured to send GTPP echo request packets, the SGSN always uses 0 as the
sequence number in those packets. Re-using 0 as a sequence number in the DRT packets is allowed by the
3GPP standards; however, this CLI command ensures the possibility of inter-operating with CGFs that can
not properly handle the re-use of sequence number 0 in the echo request packets.
sequence number in those packets. Re-using 0 as a sequence number in the DRT packets is allowed by the
3GPP standards; however, this CLI command ensures the possibility of inter-operating with CGFs that can
not properly handle the re-use of sequence number 0 in the echo request packets.
Example
The following command sets the sequence to start at 1.
The following command sets the sequence to start at 1.