Cisco Cisco Tunnel Terminating Gateway (TTG) Troubleshooting Guide
ACL Configuration Mode Commands
▀ redirect css service (by host IP address)
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
redirect css service (by host IP address)
Used to redirect subscriber sessions based on the targeted host IP address sent by the source to the mobile node or the
network.
network.
Product
All
Privilege
Security Administrator, Administrator
Syntax
Indicates all rule definitions subsequent to this command are to be inserted after the command identified by
the exact options listed.
This moves the insertion point to be immediately after the rule definition which matches the exact options
specified such that new rule definitions will be added, in order, after the matching rule definition.
the exact options listed.
This moves the insertion point to be immediately after the rule definition which matches the exact options
specified such that new rule definitions will be added, in order, after the matching rule definition.
Important:
If the options specified do not exactly match an existing rule definition, the insertion point does not
change.
Indicates all rule definitions subsequent to this command are to be inserted before the command identified by
the exact options listed.
This moves the insertion point to be immediately before the rule definition which matches the exact options
specified such that new rule definitions will be added, in order, before the matching rule definition.
the exact options listed.
This moves the insertion point to be immediately before the rule definition which matches the exact options
specified such that new rule definitions will be added, in order, before the matching rule definition.
Important:
If the options specified do not exactly match an existing rule definition, the insertion point does not
change.
Removes the rule definition which exactly matches the options specified.
The name of the active charging service to which packets are to be redirected. At the executive mode prompt,
use the
use the
command to display the names of all configured
charging services.
must be a string from 1 through 15 characters in length.