Cisco Cisco Network Assistant Version 3.0 Release Notes

These caveats apply to Cisco EtherSwitch service modules:

CSCei55046

The Front Panel view on EtherSwitch service modules NME-16ES-1G-P, NME-X-23ES-1G-P, 
NME-XD-24ES-1S-P, and NME-XD-48ES-2S-P shows the EN-LED as not enabled.

There is no workaround.

CSCsd04956

The Topology view does not show the internal Gigabit Ethernet link between routers and the 
EtherSwitch service modules NME-16ES-1G and NME-X-23ES-1G. 

There is no workaround.

CSCsd06275

The Smartports window shows the NME-XD-24ES-1S-P EtherSwitch service module with two 
Mode buttons instead of one

There is no workaround.

This section describes the resolved caveats.

These caveats were resolved in Network Assistant 3.1

CSCsc84838

Network Assistant now recognizes WS-X4306-GB linecards whose firmware is 2.0 or lower.

CSCsd00945

On Catalyst Express 500 switches, you can now associate a Cisco-Voice VLAN with a Smartports role 
other than IP Phone.

These caveats were resolved in Network Assistant 3.0(1):

CSCei85905

When you apply a Smartports role to a Catalyst 4500 or 4900 switch, the switch no longer resets or 
switches over to the standby supervisor, regardless of the Cisco IOS version that it runs.

CSCsc02206

If you manage a Catalyst 2900 XL switch as a standalone device, Network Assistant now shows its 
links to neighbor devices in a Topology view. If you manage it in a community, you can now see a 
popup window in the Topology view when you right-click one of its links.

CSCsc06400

Cisco IP phones that do not appear in the Topology view will appear when their firmware is 
upgraded.