Cisco Cisco Aironet 1400 Wireless Bridge Release Notes
4
Release Notes for Cisco Aironet 1410 Bridges for Cisco IOS Release 12.3(2)JA5
OL-8220-01
Important Notes
Stacking Bridges
You can double the throughput or create a standby link by stacking two bridges. A stacked installation
consists of two bridge systems installed at the same physical location. For detailed mounting instructions
refer to the Cisco Aironet 1400 Series Wireless Bridge Mounting Instructions that shipped with your
bridge.
consists of two bridge systems installed at the same physical location. For detailed mounting instructions
refer to the Cisco Aironet 1400 Series Wireless Bridge Mounting Instructions that shipped with your
bridge.
Note
The bridge antennas must be separated by a minimum of 6.56 ft (2 m) from each other and from other
co-located antennas.
co-located antennas.
Important Notes
This section describes important information about the bridge.
Default SSID and Distance Settings Change When You Change Role in Radio
Network
Network
If the bridge’s SSID has not been changed from the default setting and you select Install Automatic
Mode as the bridge’s role in radio network setting, the SSID automatically changes from tsunami to
autoinstall. When you change the role in radio network from Install Automatic Mode to Root or
Non-Root, the SSID changes automatically from autoinstall back to tsunami. However, if you change
the SSID from its default setting, changing the role in radio network setting does not change the SSID.
Mode as the bridge’s role in radio network setting, the SSID automatically changes from tsunami to
autoinstall. When you change the role in radio network from Install Automatic Mode to Root or
Non-Root, the SSID changes automatically from autoinstall back to tsunami. However, if you change
the SSID from its default setting, changing the role in radio network setting does not change the SSID.
In Install Automatic Mode, the default distance setting is 99 km. When you change the role in radio
network from Install Automatic Mode to Root or Non-Root, the distance setting changes automatically
from 99 km to 0 km.
network from Install Automatic Mode to Root or Non-Root, the distance setting changes automatically
from 99 km to 0 km.
Default Encryption Key 2 Is Set by Bridge
The encryption key in slot 2 is the transmit key by default. If you enable WEP with MIC, use the same
WEP key as the transmit key in the same key slot on both root and non-root bridges.
WEP key as the transmit key in the same key slot on both root and non-root bridges.
Limitation to PAgP Redundancy on Switches Connected by Bridge Links
When two switches configured for Port Aggregation Protocol (PAgP) are connected by redundant
wireless bridge links, the PAgP switchover takes at least 30 seconds, which is too slow to maintain TCP
sessions from one port to another.
wireless bridge links, the PAgP switchover takes at least 30 seconds, which is too slow to maintain TCP
sessions from one port to another.
CLI Command power client n Is Not Supported
The bridge does not support the power client n configuration interface command in the web-browser or
CLI interfaces. The bridge does not perform any action when you enter this command.
CLI interfaces. The bridge does not perform any action when you enter this command.