Cisco Cisco Aironet 1310 Access Point Bridge Release Notes

Beginning in privileged EXEC mode, follow these steps to disable the access point radios using the CLI:

If your access point has two radios, repeat these steps for the second radio. Use the no form of the 
shutdown command to enable the radio. 

No new features are introduced in Cisco IOS Release 12.3(11)JA1.

This section contains information you should keep in mind when installing 1130, 1240 series access 
points, and 1300 series outdoor access point/bridges.

Cisco Aironet 1130 and 1240 Series Access Points provide adequate fire resistance and low 
smoke-producing characteristics suitable for operation in a building's environmental air space, such as 
above suspended ceilings, in accordance with Section 300-22(C) of the National Electrical Code (NEC) 
and Sections 2-128, 12-010(3) and 12-100 of the Canadian Electrical Code, Part 1, C22.1.

The power injector does not provide fire resistance and low smoke-producing characteristics and is not 
intended for use in extremely high or low temperatures or in environmental air spaces such as above 
suspended ceilings.

This section describes issues you should consider before applying power to an access point.

Cisco Aironet power injectors are designed for use with Cisco Aironet access points and bridges only. 
Do not use the power injector with any other Ethernet-ready device. Using the power injector with other 
Ethernet-ready devices can damage the equipment.

Enter global configuration mode.

interface dot11radio {0 | 1}

Enter interface configuration mode for the radio interface. The 
2.4-GHz radio is radio 0, and the 5-GHz radio is radio 1.

Disable the radio port.

Return to privileged EXEC mode.

copy running-config startup-config (Optional) Save your entries in the configuration file.