Cisco Cisco Aironet 1310 Access Point Bridge Information Guide
AP hardware (16−MB APs have a lower limit than the 32−MB and higher APs).
♦
For complete details on client association limits, refer to the Client Association Limits section
of the Cisco Wireless LAN Controller Configuration Guide, Release 7.0.
of the Cisco Wireless LAN Controller Configuration Guide, Release 7.0.
Q. Does the 1252 AP support bridging?
A. Yes, the bridging mode is supported on the 1252 series AP.
Q. Does the Lightweight AP Protocol (LWAPP) infrastructure support
PPP over Ethernet (PPPoE) (PC client to a PPPoE server)?
PPP over Ethernet (PPPoE) (PC client to a PPPoE server)?
A. No, the LWAPP infrastructure does not support PPPoE. The reason is that the PPPoE
Ethertype is dropped at the controller.
Ethertype is dropped at the controller.
Q. How can I manually reset the Cisco Aironet 1000 Series LAP?
A. You can reset the AP to the factory defaults through the wireless LAN (WLAN) controller
(WLC). For the reset, the LAP should be registered to the WLC.
(WLC). For the reset, the LAP should be registered to the WLC.
Complete these steps:
From the WLC GUI, click Wireless. The Wireless tab provides access to the Cisco
WLAN Solution wireless network configuration.
WLAN Solution wireless network configuration.
1.
Choose Access Points > Cisco APs, and then click Detail in order to navigate to the
window for the specific AP.
window for the specific AP.
2.
Click Clear Config at the bottom of this window. This clears the configuration on the
LAP and resets it to the factory defaults.
LAP and resets it to the factory defaults.
3.
In order to reset the LAPs to the factory defaults with use of the command−line interface
(CLI), issue the clear ap−config ap−name command from the WLC CLI.
(CLI), issue the clear ap−config ap−name command from the WLC CLI.
Q. Where can I get more information on Cisco Aironet 1000 Series LAPs?
A. Refer to Cisco 1000 Series Lightweight Access Points − Q&A. The document provides
answers to many questions that relate to the 1000 Series LAPs.
answers to many questions that relate to the 1000 Series LAPs.
Q. Which Cisco devices support Lightweight AP Protocol (LWAPP) Layer
2 mode?
2 mode?
A. LWAPP Layer 2 mode is only supported on these Cisco devices:
Cisco 4100 Series Wireless LAN Controller (WLC)
♦
Cisco 4400 Series WLC
♦
Cisco Aironet 1000 Series LAP
♦
Q. I understand that the Cisco LAPs use a Vendor Class Identifier (VCI)
string with DHCP option 43 for controller discovery. What is the VCI
string value for Cisco LAPs?
string with DHCP option 43 for controller discovery. What is the VCI
string value for Cisco LAPs?
A. Cisco Aironet 1000 Series APs use a string format for DHCP option 43, whereas the other
Aironet APs use the type, length, value (TLV) format for DHCP option 43. You must
program DHCP servers to return the option on the basis of the AP DHCP VCI string (DHCP
Aironet APs use the type, length, value (TLV) format for DHCP option 43. You must
program DHCP servers to return the option on the basis of the AP DHCP VCI string (DHCP