Cisco Cisco Aironet 1310 Access Point Bridge Release Notes
10
Release Notes for Cisco Aironet 1300 Series Outdoor Access Point/Bridge for Cisco IOS Release 12.3(7)JA1
OL-8207-01
Important Notes
Corrupt EAP Packet Sometimes Causes Error Message
During client authentication, the access point/bridge sometimes receives a corrupt EAP packet and
displays this error message:
displays this error message:
Oct 1 09:00:51.642 R: %SYS-2-GETBUF: Bad getbuffer, bytes= 28165
-Process= "Dot11 Dot1x process", ipl= 0, pid= 32
-Traceback= A2F98 3C441C 3C7184 3C604C 3C5E14 3C5430 124DDC
You can ignore these messages.
When Cipher is TKIP Only, Key Management Must Be Enabled
When “Cipher TKIP” is configured on a VLAN, the SSID(s) for that VLAN must use WPA or CCKM
key management. If you do not configure the SSID(s) for that VLAN with WPA or CCKM, client
authentication fails on the SSIDs.
key management. If you do not configure the SSID(s) for that VLAN with WPA or CCKM, client
authentication fails on the SSIDs.
Non-Cisco Aironet Clients Sometimes Fail 802.1x Authentication
Some non-Cisco Aironet client adapters do not perform 802.1x authentication to the access point/bridge
unless you configure Open authentication with EAP. To allow both Cisco Aironet clients using LEAP
and non-Cisco Aironet clients using LEAP to associate using the same SSID, you might need to
configure the SSID for both Network EAP authentication and Open authentication with EAP.
unless you configure Open authentication with EAP. To allow both Cisco Aironet clients using LEAP
and non-Cisco Aironet clients using LEAP to associate using the same SSID, you might need to
configure the SSID for both Network EAP authentication and Open authentication with EAP.
Pings and Link Tests Sometimes Fail to Clients with both Wired and Wireless
Network Connections
Network Connections
When you ping or run a link test from an access point to a client device installed in a PC running
Microsoft Windows 2000, the ping or link test sometimes fails when the client has both wired and
wireless connections to the LAN. Microsoft does not recommend this configuration. For more
information, refer to Microsoft Knowledge Base article 157025 at this URL:
Microsoft Windows 2000, the ping or link test sometimes fails when the client has both wired and
wireless connections to the LAN. Microsoft does not recommend this configuration. For more
information, refer to Microsoft Knowledge Base article 157025 at this URL:
Limitation to PAgP Redundancy on Switches Connected by Bridge Links
When running PAgP on switched connected to series bridges, for ethernet traffic redundancy and load
balance be aware that PAgP switchover takes at least 30 seconds, which is too slow to maintain certain
traffic (for example, TCP) when switching from port to the other. There is no workaround for this
limitation.
balance be aware that PAgP switchover takes at least 30 seconds, which is too slow to maintain certain
traffic (for example, TCP) when switching from port to the other. There is no workaround for this
limitation.