Cisco Cisco Aironet 1310 Access Point Bridge Installation Guide
15
Quick Start Guide Cisco Aironet 1300 Series Access Point
Caution
Do not interrupt the boot process or the configuration file will
be damaged. Wait until the access point/bridge Install Mode
LED begins to blink green before continuing with CLI
configuration changes. You will see the following CLI message
when the load process has finished: Line protocal on Interface
Dot11Radio0, changed state to up.
be damaged. Wait until the access point/bridge Install Mode
LED begins to blink green before continuing with CLI
configuration changes. You will see the following CLI message
when the load process has finished: Line protocal on Interface
Dot11Radio0, changed state to up.
5.
After the access point/bridge reboots, you can reconfigure it with the
Web-browser interface or the CLI.
Web-browser interface or the CLI.
The access point/bridge is configured with the factory default values
including the IP address (set to receive an IP address using DHCP). To obtain
the access point/bridge’s new IP address, you can use the show interface bvi1
CLI command.
including the IP address (set to receive an IP address using DHCP). To obtain
the access point/bridge’s new IP address, you can use the show interface bvi1
CLI command.