Cisco Cisco Aironet 1310 Access Point Bridge Installation Guide
30
78-15954-02
•
You cannot assign an SSID to a VLAN that is already configured on the
bridge. To assign an SSID to an existing VLAN, use the Security SSID
Manager page.
bridge. To assign an SSID to an existing VLAN, use the Security SSID
Manager page.
You cannot configure combinations of authentication types on the same SSID
(such as MAC address authentication and EAP authentication). To configure
combinations of authentication types, use the Security SSID Manager page.
(such as MAC address authentication and EAP authentication). To configure
combinations of authentication types, use the Security SSID Manager page.
Configuring Advanced Parameters
Your bridge is now running but probably requires additional configuring to
conform to your network’s operational and security requirements. Refer to
the Cisco Aironet 1300 Series Outdoor Access Point/Bridge Software
Configuration Guide for detailed information and instructions. The following
table lists the chapters you need to consult.
conform to your network’s operational and security requirements. Refer to
the Cisco Aironet 1300 Series Outdoor Access Point/Bridge Software
Configuration Guide for detailed information and instructions. The following
table lists the chapters you need to consult.
For information on
Go to
Using the command line interface
Chapter 4
Configuring radio settings
Chapter 6
Configuring SSIDs (including multiple SSIDs)
Chapter 7
Configuring Spanning Tree Protocol
Chapter 8
Configuring WEP and WEP features (TKIP, MIC)
Chapter 9
Configuring authentication types (LEAP)
Chapter 10