Cisco Cisco Aironet 350 Wireless Bridge Technical Manual
When you have configured the parameters in Step 2, click OK.
With these settings, the access point or bridge is ready to authenticate LEAP clients against a
RADIUS server.
RADIUS server.
3.
Configuring the Funk Software, Inc. Product, Steel−Belted Radius
Complete the steps in the next procedure to configure the Funk Software, Inc. product, Steel−Belted Radius,
to communicate with the access point or bridge. For more complete information on the server, refer to Funk
Software
to communicate with the access point or bridge. For more complete information on the server, refer to Funk
Software
.
Note: The portions of this document that refer to non−Cisco products were written based on experience the
author had with that non−Cisco product, not on formal training. They are intended for the convenience of
Cisco customers, not as technical support. For authoritative technical support on non−Cisco products, contact
the product technical support for the vendor.
author had with that non−Cisco product, not on formal training. They are intended for the convenience of
Cisco customers, not as technical support. For authoritative technical support on non−Cisco products, contact
the product technical support for the vendor.
On the RAS Clients menu, click Add to create a new RAS Client.
1.
Configure the parameters for client name, IP address and make/model.
Client Name: Enter the name of the access point or bridge.
a.
IP Address: Enter the address of the access point or bridge that communicates with
Steel−Belted Radius.
Steel−Belted Radius.
b.
2.