Cisco Cisco WAP4410N Wireless-N Access Point - PoE Advanced Security Maintenance Manual

Setup

WAP4410N Wireless-N Access Point with Power Over Internet Administration Guide

25

Click Setup > Basic Setup.

From the IP Settings drop-down menu, select one of the following options:

•

Static IP Address—Select this option to assign a static or fixed IP address 
to the access point. 

•

Automatic Configuration—Select this option to automatically configure 
the IPv4 network settings of the access point using a DHCP server on your 
network. Also select this option to automatically configure the IPv6 network 
settings of the access point using an IPv6 RADVD device enabled on your 
network.

If you select Static IP Address from the IP Settings drop-down menu, enter the 
following information in the IPv4 section of the screen:

•

Local IP Address—Enter a unique IP address for your access point. The 
default IP address is 192.168.1.245.

•

Subnet Mask—Enter the same subnet mask used in your network. The 
default is 255.255.255.0.

•

Default Gateway—Enter the IP address of your Gateway or Router. Enter 
the value used by other devices on your LAN. 

•

Primary DNS—Enter the IP address of your primary DNS server. 

•

Secondary DNS—Enter the IP address of your secondary DNS server. 

To configure the IPv6 settings for your access point:

•

IPv6—Select Enabled to enable IPv6 for your access point.

•

Accept Router Advertisement—Check this check box to accept router 
advertisement.

•

Local IP Address—Enter a unique IP address for your access point. 

•

Default Gateway—Enter the IP address of your gateway or router. This 
address is used by the other devices on your network.

•

Primary DNS—Enter the IP address of your primary DNS server. 

•

Secondary DNS—Enter the IP address of your secondary DNS server. 

Click Save.