Cisco Cisco AMP Threat Grid 5500 Appliance Installation Guide
Cisco AMP Threat Grid Appliance Setup and Configuration Guide
SERVER SETUP
SERVER SETUP
10
SERVER SETUP
To begin, connect both power supplies on the back of your appliance and connect the included KVM adapter to
an external monitor and keyboard and plug into the KVM port located at the front of the server, as illustrated in
the figure below.
an external monitor and keyboard and plug into the KVM port located at the front of the server, as illustrated in
the figure below.
If CIMC is configured, you can use a remote KVM. For CIMC configuration see Configuring CIMC (Optional) in
the Appendix.
the Appendix.
Please refer to the server product documentation for detailed hardware and environmental setup information.
Links to product documentation are provided in the Hardware Documentation section, above.
Links to product documentation are provided in the Hardware Documentation section, above.
Network Interface Connections Setup
Find the SFP+ ports (there are two) and the three Ethernet ports on the back of the appliance and attach the
network cables as illustrated below:
network cables as illustrated below:
Figure 3 - Cisco UCS C220 M3 SFF Rack Server
The interfaces must be properly connected and configured for the appliance to operate.
Note:
The details of your appliance may differ from the image above. Please contact support@threatgrid.com
if you have any questions.
Note:
"Reserved" is the non-Admin SFP+ port, which is reserved for future use.
See the diagram below for more information about the C220 M3 server.