Cisco Cisco AMP Threat Grid 5004 Appliance Installation Guide
Cisco AMP Threat Grid Appliance Setup and Configuration Guide
CONFIGURATION WIZARD - OPADMIN PORTAL
CONFIGURATION WIZARD - OPADMIN PORTAL
27
End User License Agreement
1.
Review the End User License Agreement.
2.
Scroll down to the end, and click I HAVE READ AND AGREE. The License page opens:
Figure 18 - License Page
We recommend that you follow the configuration workflow, and configure the networks before you install the
license, as described in the next section, Network Configuration Settings.
license, as described in the next section, Network Configuration Settings.
Network Configuration Settings
If you configured your static network settings in the TGSH Dialog, the IP addresses displayed in the Network
Configuration page will reflect the values you entered in the TGSH Dialog during the appliance network
configuration.
Configuration page will reflect the values you entered in the TGSH Dialog during the appliance network
configuration.
Network Configuration and DHCP
If you used DHCP for your initial connection and now need to change the Clean and Dirty IP networks to static IP
addresses, then follow the steps in the section: Networking > Using DHCP, located in the Threat Grid Appliance
Administrator's Guide.
addresses, then follow the steps in the section: Networking > Using DHCP, located in the Threat Grid Appliance
Administrator's Guide.
Continue with the next section: