Cisco Cisco WAP4410N Wireless-N Access Point - PoE Advanced Security Release Notes
Release Notes for the Cisco WAP4410N Access Point Firmware Version 2.0.7.8
3
Release Notes
Known Issues
The following known issues exist for firmware version 2.0.6.1
•
CSCtz79103—When selecting a 128-bit WEP key and providing a pass-
phrase, one 128-bit key is generated. However, the default transmit key
radio buttons allow you to pick from keys 1 through 4. The radio buttons for
keys 2, 3, and 4 should be disabled.
phrase, one 128-bit key is generated. However, the default transmit key
radio buttons allow you to pick from keys 1 through 4. The radio buttons for
keys 2, 3, and 4 should be disabled.
•
CSCtz05386—When enabling IPv6, the link local is not displayed on the
status page. Workaround: SSH into the device and execute an ifconfig to
determine the link local.
status page. Workaround: SSH into the device and execute an ifconfig to
determine the link local.
•
CSCtz79116—The MAC Connection Control List allows empty entries to
be saved. Enabling MAC Control and not specifying MAC addresses may
disconnect your clients.
be saved. Enabling MAC Control and not specifying MAC addresses may
disconnect your clients.
•
CSCtz79129—The AP mode appears incorrectly as G when the AP is
selected to work in N-only mode.
selected to work in N-only mode.
•
CSCts76476—The access point may periodically experience loss of
connectivity when configured in bridge mode. Workaround: Unplug the
power adapter or PoE cable, and then plug it back in.
connectivity when configured in bridge mode. Workaround: Unplug the
power adapter or PoE cable, and then plug it back in.
•
CSCtz05399—The WAP4410N displays only one IPv6 address when set to
IPv6 auto-configuration. For example, if the router is advertising multiple
prefixes, a local (fec0::) and a global site (2001::), the access point only
acquires one of the two addresses.
IPv6 auto-configuration. For example, if the router is advertising multiple
prefixes, a local (fec0::) and a global site (2001::), the access point only
acquires one of the two addresses.
•
CSCtz59478—When enabling or disabling the VLAN or QoS features, your
Internet connection will be lost. Workaround: After configuring the VLAN or
QoS features, unplug the power adapter or PoE cable, and then plug it back
in.
Internet connection will be lost. Workaround: After configuring the VLAN or
QoS features, unplug the power adapter or PoE cable, and then plug it back
in.
Changes Since WAP4410N Firmware Version 2.0.4.2
The firmware was updated and the following was fixed in firmware version 2.0.5.3.
Changes Since WAP4410N Firmware Version 2.0.4.1
The firmware was updated and the following was fixed in firmware version 2.0.4.2.