Cisco Cisco Packet Data Gateway (PDG)
System Recovery
Booting from a Selected Image ▀
ASR 5000 System Administration Guide, StarOS Release 16 ▄
235
Booting from a Selected Image
You will issue a boot command via the boot CLI to initiate the system recovery process.
Boot Using No Configuration FIle
This procedure boots the system using the specified boot image without also loading a configuration file. A sample
command string appears below:
command string appears below:
8/0:cli>boot -noconfig /flash/image_filename.bin
The boot sequence ends with a prompt to enter the Quick Setup Wizard for creating a configuration file.
Launching StarOS
Starting program at 0x0000000000100000
Starent Networks ASR5x00 Intelligent Mobile Gateway
<management_card> is starting up..............................
Starting software <image_version_number>...
No configuration found, press enter to continue.
1. Do you wish to continue with the Quick Setup Wizard[yes/no]:
Starting program at 0x0000000000100000
Starent Networks ASR5x00 Intelligent Mobile Gateway
<management_card> is starting up..............................
Starting software <image_version_number>...
No configuration found, press enter to continue.
1. Do you wish to continue with the Quick Setup Wizard[yes/no]:
You can exit the Quick Setup Wizard by entering no in response to the above prompt. Load a desired configuration file
using the Exec mode configure command followed by the URL for the configuration file as shown in the example
below:
using the Exec mode configure command followed by the URL for the configuration file as shown in the example
below:
[local]<host_name># configure /flash/system.cfg
Boot Using A Specified Configuration File
This procedure boots the system using the specified boot image and configuration file. A sample command string
appears below:
appears below:
8/0:cli>boot -config=/flash/system.cfg /flash/image_filename.bin
The boot sequence ends with the appearance of the CLI prompt.
[local]<host_name>#
Confirm that the desired configuration has loaded by running the Exec mode show configuration command.